2005-2008 RAV4 · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the RH side and LH sides.
  2. The procedures listed below are for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

B129158
  1. Attach the clip and 3 claws to install the garnish.


3. REMOVE DOOR ASSIST GRIP COVER LH

4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

5. REMOVE FRONT ARMREST BASE PANEL UPPER LH

B129159
  1. Using a screwdriver, detach the clip, 5 claws, and remove the panel (with the switch).

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the switch connectors.

  1. B129161
    for Driver Side:
    Remove the 3 screws and power window regulator master switch from the panel.

    NOTICE:
    Be careful when removing the screws as the switch may fall and become damaged.

  1. B139756
    for Passenger Side:
    Using a screwdriver, detach the 2 claws and remove the power window regulator switch from the panel.

    HINT:
    Tape the screwdriver tip before.

    NOTICE:
    Be careful when detaching the claws as the switch may fall and become damaged.


6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

B129165
Using a screwdriver, detach the 12 claws and remove the door assist grip.

HINT:
B129164
Tape the screwdriver tip before use.
Using a screwdriver, detach the 3 claws and remove the door inside handle plug.

HINT:
Tape the screwdriver tip before use.

  1. B129166
    Remove the 3 screws.

  1. Using a screwdriver, detach the 10 clips, 2 claws and remove the trim.

    HINT:
    1. Tape the screwdriver tip before use.
    2. If the screwdriver cannot reach the clips, pull on the lower trim to remove it.

  1. Using a screwdriver, detach the 7 claws and remove the weatherstrip inner.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a screwdriver, detach the 4 claws and remove the speaker door grille.

    HINT:
    Tape the screwdriver tip before use.


7. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

B131486
  1. Disconnect the connector.

  1. Using a drill bit with a diameter of less than 4 mm (0.16 in.), drill out the 3 rivet heads and remove the speaker.

    NOTICE:
    1. Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.
    2. Be careful as the cut rivet will be very hot.

  1. Continue drilling and push out the remaining rivet fragments.

  1. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →