2005-2008 RAV4 · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the RH side and LH sides.
  2. The procedures listed below are for the LH side.


1. INSTALL REAR NO. 1 SPEAKER ASSEMBLY

  1. B131485
    Using an air riveter or hand riveter, install the speaker with 3 new rivets.

    NOTICE:

    1. B079664E06
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

    2. B079665E07
      Confirm that the rivets are seated properly against the speaker.
      Do not tilt the riveter when installing the rivet to the speaker.
      Do not leave any space between the rivet head and speaker.

    3. B079666E10
      Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.

  1. Connect the connector.


2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
  1. Attach the 6 claws to install the weatherstrip inner.

  1. B133485
    Attach the 2 claws to install the inside handle.

  1. B137875E01
    for 8 Clip Type:
    Attach the 8 clips to install the trim board.

  1. for 7 Clip Type:
    Attach the 7 clips to install the trim board.

  1. Install the 3 screws.

  1. B129164
    Attach the 3 claws to install the door inside handle bezel plug.

  1. B130017
    Attach the 12 claws to install the door assist grip cover.


3. INSTALL REAR DOOR ARMREST BASE PANEL UPPER LH

  1. B133495
    Attach the 2 claws and install the power window regulator switch to the panel.

  1. Connect the switch connector.

  1. B133496
    Attach the clip and 5 claws to install the panel (with the switch).


4. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

5. INSTALL DOOR ASSIST GRIP COVER LH

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← INSPECTION (from Nov 2005)PRECAUTION (from Nov 2005) →