INSPECTION
Inspection · Vehicles built from Nov 2005
| INSPECT HEATER SWITCH ASSEMBLY |
![]() ![]() |
Measure the resistance of the switch.
- Standard resistance:
Tester Connection
Switch Condition
Specified Condition
1 (IN) - 4 (IG)
ON
Below 13.1 Ω
1 (IN) - 4 (IG)
OFF
10 kΩ or higher
Apply battery voltage to the switch connector and check that the indicator light illuminates.
- OK:
Measurement Connection
Switch Condition
Specified Condition
Battery positive (+) → Terminal 4 (IG)
Battery positive (+) → Terminal 5 (E)
ON
Indicator light Illuminates
Apply battery voltage to the switch connector and check that the illumination light illuminates.
- OK:
Measurement Connection
Specified Condition
Battery positive (+) → Terminal 3 (ILL+)
Battery positive (+) → Terminal 2 (ILL-)
Illumination light Illuminates


