DISASSEMBLY
Removal / installation · Vehicles built from Nov 2005
| 1. REMOVE INPUT SHAFT REAR BEARING SHAFT SNAP RING |
Using a snap ring expander, remove the input shaft rear bearing shaft snap ring from the input shaft.

| 2. REMOVE INPUT SHAFT REAR RADIAL BALL BEARING |
Using SST, remove the input shaft rear radial ball bearing from the input shaft.

- SST
- 09950-40011
(09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04011, 09957-04010, 09958-04011)
09631-20031
| 3. REMOVE 6TH DRIVE GEAR |
Using SST and a press, press out the 6th drive gear from the input shaft.

- SST
- 09950-00020
| 4. REMOVE 3RD DRIVE GEAR |
Using SST and a press, press out the 3rd drive gear from the input shaft.

- SST
- 09950-00020
Remove the input shaft spacer from the input shaft.

| 5. REMOVE 4TH DRIVE GEAR |
Using SST and press, press out the 4th drive gear from the input shaft.

- SST
- 09950-00020
| 6. REMOVE INPUT SHAFT SNAP RING |
Using 2 screwdrivers and a hammer, tap out the input shaft snap ring from the input shaft.

| 7. REMOVE INPUT SHAFT FRONT BEARING |
Using SST and press, press out the input shaft front bearing from the input shaft.

- SST
- 09950-00020
