REASSEMBLY
Removal / installation · Vehicles built from Nov 2005
| 1. INSTALL INPUT SHAFT FRONT BEARING |
Using SST and a press, press the input shaft front bearing into the input shaft.

- SST
- 09608-00071
| 2. INSTALL INPUT SHAFT SNAP RING |
Using a brass bar and hammer, tap the snap ring onto the input shaft.

| 3. INSTALL 4TH DRIVE GEAR |
Using SST and a press, press the 4th drive gear into the input shaft.

- SST
- 09309-14040
| 4. INSTALL 3RD DRIVE GEAR |
Install the input shaft spacer into the input shaft.

Using SST and a press, press the 3rd drive gear into the input shaft.

- SST
- 09309-14040
| 5. INSTALL 6TH DRIVE GEAR |
Using SST and a press, press the 6th drive gear into the input shaft.

- SST
- 09309-14040
| 6. INSTALL INPUT SHAFT REAR RADIAL BALL BEARING |
Using SST and a press, press the input shaft rear radial ball bearing into the input shaft.

- SST
- 09506-30012
| 7. INSTALL INPUT SHAFT REAR BEARING SHAFT SNAP RING |
Using the table below, select a new snap ring that makes the thrust clearance of the input shaft bearing less than 0.1 mm (0.0039 in.).

- Standard snap ring thickness:
Mark
Thickness
Mark
Thickness
A
1.80 to 1.85 mm (0.0709 to 0.0728 in.)
3
2.20 to 2.25 mm (0.0866 to 0.0886 in.)
B
1.85 to 1.90 mm (0.0728 to 0.0748 in.)
4
2.25 to 2.30 mm (0.0886 to 0.0906 in.)
C
1.90 to 1.95 mm (0.0748 to 0.0768 in.)
5
2.30 to 2.35 mm (0.0906 to 0.0925 in.)
D
1.95 to 2.00 mm (0.0768 to 0.0787 in.)
6
2.35 to 2.40 mm (0.0925 to 0.0945 in.)
E
2.00 to 2.05 mm (0.0787 to 0.0807 in.)
F
2.40 to 2.45 mm (0.0945 to 0.0965 in.)
0
2.05 to 2.10 mm (0.0807 to 0.0827 in.)
G
2.45 to 2.50 mm (0.0965 to 0.0984 in.)
1
2.10 to 2.15 mm (0.0827 to 0.0846 in.)
H
2.50 to 2.55 mm (0.0984 to 0.1004 in.)
2
2.15 to 2.20 mm (0.0846 to 0.0866 in.)
-
-
Using a snap ring expander, install the snap ring into the input shaft.

