2005-2008 RAV4 · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007


1. INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY

C127079
  1. Install the shift lever with the 4 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

  1. C127220
    Install the 4 wire harness clamps.


2. CONNECT TRANSAXLE CONTROL CABLE ASSEMBLY

D026974E03
  1. Connect the ends of the control cable and install the 2 clips to the shift lever.

  1. D033172E03
    Turn the lock nuts of the shift cable 270° counterclockwise, and hold them in that position.

  1. Install the shift cable and select cable while holding the lock nuts.

  1. Check that the cables are installed securely.

  1. G032966E01
    Push in the cable locks of the shift cable and select cable.


3. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY

B129878
  1. Connect the connector.

  1. Install the rear console box with the 2 bolts and 2 screws.

  1. Install the console box carpet.


4. INSTALL CONSOLE REAR END PANEL

B129879
  1. Attach the 6 claws to install the console rear end panel.


5. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY

B129880
  1. Connect the connector.

  1. Attach the 4 clips to install the upper rear console panel.


6. INSTALL CONSOLE CUP HOLDER BOX

B129881
  1. Attach the 2 clips to install the cup holder box.

  1. Install the 2 screws.


7. INSTALL SWITCH BASE

B129882
  1. Connect the connectors.

  1. Attach the 2 clips and 2 claws to install the switch base.


8. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

B129883
  1. Automatic transaxle:
    Connect the connector.

  1. Attach the 2 clips and 4 claws to install the upper console panel.

  1. Install the shift lever knob.


9. INSTALL NO. 2 CONSOLE UPPER PANEL GARNISH

B129884
  1. Attach the 4 clips to install the upper panel garnish.


10. INSTALL NO. 1 CONSOLE UPPER PANEL GARNISH

B129885
  1. Attach the 4 clips to install the upper panel garnish.


11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← INSTALLATION (Nov 2005 – Dec 2006)INSTALLATION (from Aug 2007) →