2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jan 2007


1. REMOVE NO. 1 ENGINE COVER

  1. A123518
    Detach the 4 clips and remove the engine cover.


2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A124927E01
    Disconnect the mass air flow meter connector.

  1. Disconnect the wire harness clamp.

  1. Unhook the 3 hook clamps, and then remove the air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.


3. REMOVE AIR CLEANER CASE

  1. A124928E01
    Disconnect the wire harness clamp and remove the 3 bolts and air cleaner case.


4. REMOVE NO. 3 FUEL HOSE

  1. A110785
    Using pliers, grip the claws of the 2 clips and slide the 2 clips to remove the No. 3 fuel hose.


5. REMOVE FUEL HOSE PROTECTOR

  1. A160454
    Remove the bolt and the fuel hose protector.


6. REMOVE FUEL TUBE SUB-ASSEMBLY

  1. A114936
    Disconnect the exhaust fuel addition injector connector.

  1. A110783
    Turn the retainer as shown in the illustration.

  1. A110784
    Disconnect the fuel tube.

  1. A114952
    Remove the union bolt, fuel tube and gasket.


7. REMOVE NO. 1 FUEL HOSE

  1. A114892
    Using pliers, grip the claws of the 2 clips and slide the 2 clips to disconnect the No. 1 fuel hose.


8. REMOVE FUEL INLET PIPE SUB-ASSEMBLY

NOTICE:
After removing the fuel inlet pipe, cover the common rail and supply pump with electrical tape to prevent dirt from entering them.

  1. A114942
    Remove the nut and 2 fuel inlet pipe clamps.

  1. Using SST, remove the fuel inlet pipe.

    SST
    09023-38401  


9. REMOVE FUEL SUPPLY PUMP ASSEMBLY

  1. A110786
    Disconnect the fuel temperature sensor connector.

  1. Disconnect the suction control valve connector.

  1. A114894
    Remove the 2 bolts to remove the supply pump, O-ring and supply pump drive coupling.

← COMPONENTS (from Jan 2007)INSPECTION (from Jan 2007) →