2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 ENGINE COVER

  1. A123518
    Detach the 4 clips and remove the engine cover.


3. DISCONNECT ENGINE WIRE

A126799
  1. Remove the nut and disconnect the 3 sensor connectors, 2 clamps and generator wire.

  1. Disconnect the 2 injector driver connectors and clamp.

  1. Disconnect the vacuum regulating valve connector and 2 clamps.

  1. Disconnect the 4 injector connectors and 2 nuts.

  1. Remove the grommet and nut and disconnect the glow plug wire harness.

  1. Disconnect the common rail connector.

  1. Disconnect the pressure sensor connector and 2 clamps.

  1. Remove the bolt, 2 nuts and disconnect the engine wire from the engine cover bracket.

  1. Remove the nut and disconnect the engine wire from the wire bracket.


4. REMOVE FUEL INLET PIPE SUB-ASSEMBLY

NOTICE:
After removing the fuel inlet pipe, cover the common rail and the injection or supply pump with electrical tape to prevent dirt from entering them.

  1. A114942
    Remove the nut and 2 fuel inlet pipe clamps.

  1. Using SST, remove the fuel inlet pipe.

    SST
    09023-38401  


5. REMOVE INJECTION PIPE SUB-ASSEMBLY

  1. A114940
    Remove the 2 bolts and 4 injection pipe clamps.

  1. Using SST, loosen the 4 nuts at the common rail end of the 4 injection pipes.

    SST
    09023-38401  

  1. Using SST, loosen the 4 nut at the injector end of the 4 injection pipes.

    SST
    09023-12701  

  1. Remove the 4 injection pipes.


6. REMOVE COMMON RAIL ASSEMBLY

  1. A114960
    Using pliers, grip the claws of the clip and slide the clip to disconnect the No. 4 fuel hose.

  1. Remove the 2 bolts and common rail.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →