ON-VEHICLE INSPECTION
Inspection · Vehicles built from Nov 2005
- NOTICE:
- Turn the ignition switch off for 60 seconds before performing the following inspections.
- HINT:
- The type of ignition switch on this model differs according to the specifications of the vehicle. For the expressions used in this section, refer to the "EXPRESSIONS OF IGNITION SWITCH" precaution (Click here).
| CHECK ILLUMINATION DURATION OF GLOW INDICATOR LIGHT |
Turn the ignition switch on (IG), and measure the duration of time that the light remains illuminated.


- Light illumination duration:
- Refer to the graph and the table
- Light illumination duration:
Condition
Light Illumination Time
-20°C (-4°F)
10 to 12 sec.
-15°C (5°F)
5.0 to 6.0 sec.
0°C (32°F)
3.0 to 4.0 sec.
35°C (95°F)
0.4 to 1.0 sec.
| CHECK PRE-HEATING |
Turn the ignition switch on (IG) and measure the length of time that battery voltage is applied to the glow plugs.


- Standard pre-heating time:
Engine Coolant Temperature
Specified Condition
40°C (104°F) or more
1 sec.
40°C (104°F) or less
Refer to the graph*1
(15 sec. at the longest)
If the pre-heating time is not as specified in both the table and graph, replace the glow plug.
While cranking the engine, measure the length of time that battery voltage is applied to the glow plugs.
- Standard pre-heating time:
Engine Coolant Temperature
Specified Condition
40°C (104°F) or more
1 sec.
40°C (104°F) or less
Refer to the graph*1
(15 sec. at the longest)
If the pre-heating time is not as specified in both the table and graph, replace the glow plug.
| CHECK AFTER GLOW TIME |
Remove the glow plug relay.
After the engine starts, measure the length of time that battery voltage remains present.



- Standard after glow time:
Tester Connection
Specified Condition
B43-2 - Body ground
Refer to graph below
