2005-2008 RAV4 · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007

NOTICE:
Turn the ignition switch off for 60 seconds before performing the following inspections.

HINT:
The type of ignition switch on this model differs according to the specifications of the vehicle. For the expressions used in this section, refer to the "EXPRESSIONS OF IGNITION SWITCH" precaution (Click here).


CHECK ILLUMINATION DURATION OF GLOW INDICATOR LIGHT (for CCo)

  1. Turn the ignition switch on (IG), and measure the duration of time that the light remains illuminated.

    A135619E01

    Light illumination duration:
    Refer to the graph and the table.

    If the glow plug indicator light is not illuminated as shown in the graph and the table below, replace the glow plug.

    Light illumination duration:
    Condition
    Light Illumination Time
    -20°C (-4°F)
    10 to 12 sec.
    -15°C (5°F)
    6 to 7.2 sec.
    15°C (59°F)
    0.46 to 2.4 sec.
    32°C (89.6°F)
    0.46 sec.


CHECK ILLUMINATION DURATION OF GLOW INDICATOR LIGHT (for DPF)

  1. Turn the ignition switch on (IG), and measure the duration of time that the light remains illuminated.

    A166867E01

    Light illumination duration:
    Refer to the graph and the table.

    If the glow plug indicator light is not illuminated as shown in the graph and the table below, replace the glow plug.

    Light illumination duration:
    Condition
    Light Illumination Time
    -20°C (-4°F)
    10 to 12 sec.
    -15°C (5°F)
    5.0 to 6.0 sec.
    0°C (32°F)
    3.0 to 4.0 sec.
    35°C (95°F)
    0.45 to 1.0 sec.


CHECK PRE-HEATING

  1. Turn the ignition switch on (IG) and measure the length of time that battery voltage is applied to the glow plugs.

    A124925E01

    Standard pre-heating time:
    Engine Coolant Temperature
    Specified Condition
    40°C (104°F) or more
    1 sec.
    40°C (104°F) or less
    Refer to the graph*1
    (15 sec. at the longest)

    *1: Pre-heating time changes depending on battery voltage.
    If the pre-heating time is not as specified in both the table and graph, replace the glow plug.

  1. While cranking the engine, measure the length of time that battery voltage is applied to the glow plugs.

    Pre-heating time:
    Engine Coolant Temperature
    Specified Condition
    40°C (104°F) or more
    1 sec.
    40°C (104°F) or less
    Refer to the graph*1
    (15 sec. at the longest)

    *1: Pre-heating time changes depending on battery voltage.
    If the pre-heating time is not as specified in both the table and graph, replace the glow plug.


CHECK AFTER GLOW TIME
  1. Remove the glow plug relay.

  1. A113727E04
    A165794E01
    After the engine starts, measure the length of time that battery voltage remains present.

    After glow time:
    Tester Connection
    Specified Condition
    B43-2 - Body ground
    Refer to graph below

← ON-VEHICLE INSPECTION (Nov 2005 – Dec 2006)PRECAUTION (from Nov 2005) →