Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006from Jan 2007
HINT:
Use high-temperature grease to lubricate the bearings, gears, return spring and steel ball when assembling the starter.
1.
INSTALL PLANETARY GEAR
Apply grease to the planetary gears of the planetary shaft.
Install the 3 planetary gears.
2.
INSTALL STARTER ARMATURE PLATE
Insert the plate to the starter center bearing clutch.
Check that the tab of the starter armature plate fits over the groove of the starter center bearing clutch.
3.
INSTALL STARTER ARMATURE ASSEMBLY
Install the starter armature to the starter center bearing clutch.
Align the tab of the starter center bearing clutch with the notch of the starter yoke, and install the starter yoke.
Install the brush holder.
Using a screwdriver, hold the brush spring back and connect the brush into the brush holder.
Connect the 4 brushes.
4.
INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY
Install the starter commutator end frame with the 2 screws.
Torque:
3.8 N*m{
39 kgf*cm
, 33 in.*lbf
}
5.
INSTALL STARTER DRIVE HOUSING ASSEMBLY
Install the starter pinion drive lever to the starter center bearing clutch.
Install the rubber seal to the starter pinion drive lever.
Align the 2 protrusions of the starter center bearing clutch with the 2 cutouts of the starter drive housing, and install the starter center bearing clutch to the starter drive housing.
Using a T25 "torx" driver, install the starter drive housing with the 2 bolts.
Torque:
6.0 N*m{
61 kgf*cm
, 53 in.*lbf
}
6.
INSTALL STARTER MAGNETIC SWITCH ASSEMBLY
Hook the plunger hook on the upper side of the starter pinion drive lever.
Install the spring to the starter magnetic switch.
Install the starter magnetic switch with the 3 nuts.
Torque:
2.3 N*m{
23 kgf*cm
, 20 in.*lbf
}
Connect the lead wire to the terminal with the nut.