2005-2008 RAV4 · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2007


CHECK RADIATOR RESERVOIR CAP SUB-ASSEMBLY

  1. A112200
    Measure the valve opening pressure.

    1. If there are water stains or foreign matter on O-ring 1, clean it with water and finger scouring.

    2. Check that O-ring 1 is not deformed, cracked or swollen.

    3. Apply engine coolant to O-ring 1 and rubber packing 2 before using a radiator cap tester.

    4. A110393E01
      When using the cap tester, tilt it upwards 30° or more.

    5. Pump the cap tester several times, and check the maximum pressure*.

      Pump speed:
      1 pump per second

      *: Even if the cap cannot maintain the maximum pressure, it is not defective.

      Judgement criterion:
      Item
      Specified Condition
      Standard value
      (for brand-new cap)
      93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
      Minimum standard value
      (for used cap)
      78.5 kPa (0.8 kgf/cm2, 11.4 psi)

      If the maximum pressure is less than the minimum standard value, replace the radiator reservoir cap sub-assembly.

← COMPONENTS (from Aug 2007)ON-VEHICLE CLEANING (from Aug 2007) →