2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jan 2007


1. INSTALL AIR FUEL RATIO SENSOR

  1. A126974E01
    Using SST, install the sensor to the front exhaust pipe.
    SST
    09224-00010  

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST
    44 N*m{ 449 kgf*cm , 32 ft.*lbf } for use without SST

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
    2. Make sure that SST and a wrench are connected in a straight line.

  1. A126972
    Connect the sensor connector.


2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

3. INSPECT FOR EXHAUST GAS LEAK
If exhaust gas is leaking, repair the leak. Replace damaged parts as necessary.
← INSPECTION (from Jan 2007)COMPONENTS (from Jan 2007) →