2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY

  1. A125339E01
    Apply a light coat of gasoline or spindle oil to the O-ring of the fuel pressure pulsation damper.

  1. A125338
    Install the fuel pressure pulsation damper with the 2 bolts.

    Torque:
    9.0 N*m{ 90 kgf*cm , 80 in.*lbf }

    NOTICE:
    Make sure that the O-ring is not cracked or jammed when installing.


2. INSTALL FUEL TUBE
  1. Connect the fuel main tube.

  1. Push the fuel tube connector until it makes a "click" sound.

  1. Install the fuel pipe clamp.

  1. Install the fuel tube to the fuel hose clamp.


3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
  1. Install the air cleaner filter element onto the air cleaner case.

  1. A124568
    Insert the hinge part of the air cleaner cap into the air cleaner case, and then fasten the 2 hook clamps.

  1. A124569E01
    Align the matchmarks of the No. 1 air cleaner hose and throttle body. Then connect the air cleaner hose No. 1 to the throttle body, and push apart the tabs of the No. 1 air cleaner hose clamp.

    NOTICE:
    Make sure that the hose clamp is at the correct angle.

  1. A124560
    Connect the purge line hose to the clamp.

  1. Connect the No. 2 ventilation hose to the air cleaner hose.

  1. A124559
    Connect the 4 wire harness clamps.

  1. Connect the mass air flow meter connector.


4. INSTALL NO. 1 ENGINE COVER

  1. A124558
    Install the cover with the 2 nuts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }


5. CONNECT CABLE TO BATTERY NEGATIVE TERMINAL

6. CHECK FOR FUEL LEAKS

B127990E01
  1. Make sure that there are no fuel leaks after performing maintenance on the fuel system.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG), and push the intelligent tester main switch ON.

      NOTICE:
      Do not start the engine.

    3. Select the Active Test mode on the intelligent tester.

      HINT:
      Refer to the intelligent tester operator's manual for further details.

    4. Check that there are no leaks from the fuel system.

    5. Turn the ignition switch off.

    6. Disconnect the intelligent tester from the DLC3.

← REMOVAL (from Aug 2007)COMPONENTS (from Nov 2005) →