2005-2008 RAV4 · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2007


CHECK CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
  1. Check the operation.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Turn the intelligent tester main switch on.

    4. Start and warm up the engine.

    5. Enter the following menus: Powertrain / Engine and ECT/ Active Test / Control the VVT System (Bank 1).

    6. Operate the oil control valve using the intelligent tester, and then check the engine speed.

      Standard condition:
      Condition
      Specified Condition
      Oil control valve is OFF
      Normal engine speed
      Oil control valve is ON
      Rough idling or engine stalls

      If the operation is not as specified, check the oil control valve, wire harness and ECM.

← COMPONENTS (from Aug 2007)REMOVAL (from Aug 2007) →