2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2007


1. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 2 bolts, 4 screw, 10 clips and under cover.


2. DRAIN ENGINE COOLANT
  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator reservoir cap.

    CAUTION:
    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the 2 cylinder block drain cock plugs.

    A126964E01


3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

4. REMOVE V-BANK COVER SUB-ASSEMBLY

  1. A137900
    Detach the 3 clips and remove the V-bank cover.


5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A173728
    Disconnect the mass air flow meter connector.

  1. Disconnect the VSV (air intake control) connector.

  1. Disconnect the 2 wire harness clamps and 2 vacuum hoses.

  1. Disconnect the No. 2 ventilation hose from the air cleaner hose.

  1. Loosen the No. 1 air cleaner hose clamp.

  1. Unfasten the 2 hook clamps, and then remove the air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.


6. REMOVE THROTTLE BODY

  1. A139006
    Disconnect the 2 water by-pass hoses from the throttle body.

  1. A139007
    Disconnect the control motor connector.

  1. Remove the 4 bolts, throttle body and wire harness clamp stay.

  1. Remove the gasket from the intake air surge tank.

← ON-VEHICLE INSPECTION (from Aug 2007)INSPECTION (from Aug 2007) →