2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL CAMSHAFT POSITION SENSOR

A095434E01

NOTICE:
Make sure that the O-ring is not cracked or jammed when installing.

  1. Apply a light coat of engine oil to the O-ring of the sensor.

  1. A124557
    Install the sensor with the bolt.

    Torque:
    9.0 N*m{ 90 kgf*cm , 80 in.*lbf }

  1. Connect the sensor connector.


2. INSTALL AIR CLEANER CAP
  1. Install the air cleaner filter element onto the air cleaner case.

  1. A124568
    Insert the hinge part of the air cleaner cap into the air cleaner case, and then fasten the 2 hook clamps.

  1. A124569E01
    Align the matchmarks of the No. 1 air cleaner hose and throttle body. Then connect the air cleaner hose No. 1 to the throttle body, and push apart the tabs of the No. 1 air cleaner hose clamp.

    NOTICE:
    Make sure that the hose clamp is at the correct angle.

  1. A124560
    Connect the purge line hose to the clamp.

  1. Connect the No. 2 ventilation hose to the air cleaner hose.

  1. A124559
    Connect the 4 wire harness clamps.

  1. Connect the mass air flow meter connector.


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

4. CHECK FOR ENGINE OIL LEAKS
  1. Start the engine, and check that there are no oil leaks.


5. INSTALL NO. 1 ENGINE COVER

  1. A124558
    Install the cover with the 2 nuts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →