2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL CRANKSHAFT POSITION SENSOR

A095436E01

NOTICE:
Make sure that the O-ring is not cracked or jammed when installing it.

  1. Apply a light coat of engine oil to the O-ring of the sensor.

  1. A116845E01
    Install the sensor with the bolt.

    Torque:
    9.0 N*m{ 90 kgf*cm , 80 in.*lbf }

  1. Install the wire harness clamp.

  1. Install the connector clamp.

  1. Connect the sensor connector.

  1. Confirm that the wire harness of the sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.


2. INSTALL GENERATOR ASSEMBLY
  1. Install the generator to the vehicle (Click here).


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

4. CHECK FOR ENGINE OIL LEAKAGE
← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →