2005-2008 RAV4 · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. REMOVE GENERATOR PULLEY WITH CLUTCH

  1. A126771
    Remove the cap from the pulley.

    1. Using a screwdriver, puncture the center of the cap and pry it off.

      NOTICE:
      Do not reuse the cap.

  1. A126778E01
    Install SST to the pulley and vise as shown in the illustration.
    SST
    09820-63020  

  1. Mount SST (A) in a vise.

  1. A126779E01
    Turn SST (B) clockwise to loosen the pulley.

  1. Remove the pulley.


2. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

A130331
  1. Remove the 3 nuts and generator rear end cover.

  1. A097461E01
    Remove the terminal insulator.

  1. A097462E01
    Remove the 2 screws and generator brush holder.


3. REMOVE GENERATOR ROTOR ASSEMBLY

  1. A097464E01
    Remove the bolt and cord clip.

  1. A097465E01
    Remove the 4 bolts.

  1. A122144E01
    Using SST, remove the coil.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010)

  1. Remove the washer.

  1. Remove the generator rotor.

← REMOVAL (from Nov 2005)INSPECTION (from Nov 2005) →