2005-2008 RAV4 · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL GENERATOR ROTOR ASSEMBLY

  1. A097468
    Install the washer onto the generator rectifier end frame.

  1. A097467E01
    Install the generator rotor onto the generator rectifier end frame.

  1. A097475E02
    Using a 32 mm socket wrench and press, slowly push the generator drive end frame onto the generator rectifier end frame.

  1. A097465E01
    Tighten the 4 bolts.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }

  1. A097464E01
    Install the cord clip with the bolt.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }


2. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY

  1. A079315E04
    While pushing the 2 brushes into the generator brush holder, insert a 1.0 mm (0.039 in.) pin into the generator brush holder.

  1. A097463E02
    Install the generator brush holder with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }

  1. Pull the pin out of the generator brush holder.

  1. A097461E01
    Install the terminal insulator onto the generator rectifier end frame.

  1. A098216E01
    Install the generator rear end cover with the 3 nuts.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }


3. INSTALL GENERATOR PULLEY WITH CLUTCH
  1. Install the pulley by hand.

  1. A126778E01
    Install SST to the pulley and vise as shown in the illustration.
    SST
    09820-63020  

  1. A126782E01
    Turn SST (B) counterclockwise to tighten the pulley.

    Torque:
    111 N*m{ 1125 kgf*cm , 81 ft.*lbf }

  1. Install a new cap to the pulley.

  1. Check that the generator pulley rotates smoothly.

← REPLACEMENT (from Nov 2005)INSTALLATION (from Nov 2005) →