2005-2008 RAV4 · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL GENERATOR ROTOR ASSEMBLY

  1. A097468
    Install the washer onto the generator rectifier end frame.

  1. A097467E01
    Install the generator rotor onto the generator rectifier end frame.

  1. A097475E02
    Using a 32 mm socket wrench and press, slowly push the generator drive end frame onto the generator rectifier end frame.

  1. A097465E01
    Tighten the 4 bolts.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }

  1. A097464E01
    Install the cord clip with the bolt.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }


2. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY

  1. A079315E04
    While pushing the 2 brushes into the generator brush holder, insert a 1.0 mm (0.039 in.) pin into the generator brush holder.

  1. A097463E02
    Install the generator brush holder with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }

  1. Pull the pin out of the generator brush holder.

  1. A097461E01
    Install the terminal insulator onto the generator rectifier end frame.

  1. A098216E01
    Install the generator rear end cover with the 3 nuts.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }


3. INSTALL GENERATOR PULLEY

A097459E01
SST
09820-63011   (09820-06010)
09820-06021  
  1. Install the generator pulley onto the generator rotor shaft, and then temporarily tighten the generator pulley nut by hand.

  1. A097454E02
    Tighten SST 1-B to the specified torque, and then fix SST 1-A on the generator rotor shaft.
    Item
    Part No.
    SST 1-A and B
    09820-06010
    SST 2
    09820-06021

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Securely fix SST on the generator rotor shaft.

  1. A097455E02
    Clamp SST 2 in a vise.

  1. Insert SST 1-A and B into SST 2, and then fix the generator pulley nut into SST 2.

  1. A097457E02
    Turn SST 1-A in the direction shown, and then loosen the generator pulley nut.

    Torque:
    133 N*m{ 1,356 kgf*cm , 98 ft.*lbf }

  1. Remove the generator from SST 2.

  1. A097458E02
    Fix SST 1-B in place, then loosen SST 1-A in the direction shown. Remove SST 1-A and B from the generator.

  1. Turn the generator pulley, and then check that the generator pulley moves smoothly.

← REPLACEMENT (from Nov 2005)INSTALLATION (from Nov 2005) →