2005-2008 RAV4 · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007

HINT:
  1. It is normal for the cooling fan to sometimes rotate when the ignition switch is turned from ACC to ON.
  2. The type of ignition switch in this model differs according to the specifications of the vehicle. For the expressions used in this section, refer to the "EXPRESSIONS OF IGNITION SWITCH" precaution (Click here).


CHECK COOLING FAN OPERATION AT LOW TEMPERATURES (Below 94°C (201°F))
  1. Turn the ignition switch ON with the A/C switch OFF.

  1. A127842
    Check that the cooling fan stops.
    If it does not, check the cooling fan relays and engine coolant temperature sensor, and then check for disconnection of the connector or a wire break between the cooling fan relay and engine coolant temperature sensor.

  1. A112176
    Disconnect the engine coolant temperature sensor connector.

  1. A127843
    Check that the cooling fan rotates.
    If it does not, check the fuses, cooling fan relays, ECM and cooling fan, and then check for an open circuit between the cooling fan relay and engine coolant temperature sensor.

  1. Reconnect the engine coolant temperature sensor connector.


CHECK COOLING FAN OPERATION AT HIGH TEMPERATURES (Above 96°C (205°F))
  1. Start the engine, and then raise the coolant temperature to above 96°C (205°F).

    HINT:
    Coolant temperature is the value detected by the engine coolant temperature sensor on the cylinder head.

  1. Check that the A/C switch is OFF.

  1. A127843
    Check that the cooling fan rotates.
    If it does not, check the engine coolant temperature sensor, cooling fan, harness or connector.

← SYSTEM DIAGRAM (from Nov 2005)ON-VEHICLE INSPECTION (from Jan 2007) →