Removal / installation · Vehicles built from Nov 2005
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2.
REMOVE NO. 1 ENGINE UNDER COVER
3.
REMOVE FRONT FENDER APRON RH
4.
REMOVE RADIATOR SUPPORT OPENING COVER
5.
DRAIN ENGINE COOLANT
Loosen the radiator drain cock plug.
HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.
Remove the radiator reservoir cap.
CAUTION:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Loosen the cylinder block drain cock plug.
6.
REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH
Remove the 4 bolts and reinforcement RH.
7.
REMOVE FAN AND GENERATOR V BELT
Using SST and 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then remove the fan and generator V belt.
SST
09216-42010
NOTICE:
Be sure to connect SST and the tools so that they are in line during use.
When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.
After the tensioner is fully retracted, do not apply force any more than necessary.
8.
REMOVE GENERATOR ASSEMBLY
Disconnect the generator connector.
Remove the terminal cap.
Remove the nut and disconnect the generator wire.
Remove the bolt and wire harness clamp bracket.
Remove the wire harness clamps.
Remove the 2 bolts and generator.
9.
REMOVE WATER PUMP PULLEY
Using SST, remove the 4 bolts and water pump pulley.
SST
09960-10010
(09962-01000, 09963-00700)
10.
REMOVE WATER PUMP ASSEMBLY
Remove the clamp of the crankshaft position sensor from the water pump.
Disconnect the wire of the crankshaft position sensor from the clamp bracket.
Remove the 4 bolts, 2 nuts and clamp bracket.
Using a screwdriver, pry between the water pump and cylinder block, and then remove the water pump.
NOTICE:
Be careful not to damage the contact surfaces of the water pump and cylinder block.