2005-2008 RAV4 · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2005


DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


REMOVE ENGINE ROOM NO. 2 RELAY BLOCK COVER

INSPECT NO. 1 FAN RELAY (Marking: FAN NO. 1)

B060778E45
  1. Remove the relay from the engine room No. 2 relay block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 Ω or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    1. If the result is not as specified, replace the relay.

  1. Install the relay.


INSPECT NO. 2 FAN RELAY (Marking: FAN NO. 2)

A087121E01
  1. Remove the relay from the engine room No. 2 relay block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 4
    Below 1 Ω
    3 - 5
    10 Ω or higher
    3 - 4
    10 Ω or higher
    (when battery voltage is applied to terminals 1 and 2)
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    1. If the result is not as specified, replace the relay.

  1. Install the relay.


INSPECT NO. 3 FAN RELAY (Marking: FAN NO. 3)

B060778E45
  1. Remove the relay from the engine room No. 2 relay block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 Ω or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    1. If the result is not as specified, replace the relay.

  1. Install the relay.


INSTALL ENGINE ROOM NO. 2 RELAY BLOCK COVER

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← INSTALLATION (from Aug 2007)COMPONENTS (from Nov 2005) →