2005-2008 RAV4 · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Using SST, discharge the refrigerant gas.

    SST
    07110-58060   (07117-58060, 07117-58070, 07117-58080, 07117-58090, 07117-78050, 07117-88060, 07117-88070, 07117-88080)


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


3. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE

  1. H102041
    Remove the bolt and disconnect the cooler refrigerant suction hose from the cooler compressor.

  1. Remove the O-ring from the cooler refrigerant suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.


4. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

  1. H102038
    Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler compressor.

  1. Remove the O-ring from the cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.


5. REMOVE NO. 1 ENGINE UNDER COVER

  1. A123517E02
    Using SST and 22 mm wrench, rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V-ribbed belt.
    SST
    09216-42010  

    NOTICE:
    Make sure SST is installed as shown in the illustration. If not, SST and/or the V-ribbed belt may not be able to be removed.


6. REMOVE FAN AND GENERATOR V BELT

  1. A123517E02
    Using SST and 22 mm wrench, rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V-ribbed belt.
    SST
    09216-42010  

    NOTICE:
    Make sure SST is installed as shown in the illustration. If not, SST and/or the V-ribbed belt may not be able to be removed.


7. REMOVE COOLER COMPRESSOR ASSEMBLY

E126953
  1. Disconnect the connector.

  1. w/o Stud Bolt:
    Remove the 4 bolts and cooler compressor.

  1. w/ Stud Bolt:
    Remove the 3 bolts, nut and cooler compressor.

← COMPONENTS (from Nov 2005)INSTALLATION (from Nov 2005) →