REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM |
Start up the engine.
Turn the A/C switch ON.
Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.
Stop the engine.
Using SST, discharge the refrigerant gas.
- SST
- 07110-58060
(07117-58060, 07117-58070, 07117-58080, 07117-58090, 07117-78050, 07117-88060, 07117-88070, 07117-88080)
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 3. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE |
Remove the bolt and disconnect the cooler refrigerant suction hose from the cooler compressor.

Remove the O-ring from the cooler refrigerant suction hose.
- NOTICE:
- Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
| 4. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler compressor.

Remove the O-ring from the cooler refrigerant discharge hose.
- NOTICE:
- Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
| 5. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 4 bolts, 12 clips and engine under cover.
| 6. REMOVE FAN AND GENERATOR V BELT |
Using SST and 22 mm wrench, rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V-ribbed belt.

- SST
- 09216-42010
- NOTICE:
- Make sure SST is installed as shown in the illustration. If not, SST and/or the V-ribbed belt may not be able to be removed.
| 7. REMOVE COOLER COMPRESSOR ASSEMBLY |
Disconnect the connector.

w/o Stud Bolt:
Remove the 4 bolts and cooler compressor.
w/ Stud Bolt:
Remove the 3 bolts, nut and cooler compressor.
