2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

  1. A114959
    Install a new gasket, the exhaust fuel addition injector and nozzle holder clamp with the washer and bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }

    HINT:
    Install the nozzle holder clamp while holding it.


2. INSTALL FUEL TUBE SUB-ASSEMBLY

  1. A114952
    Install a new gasket and the fuel tube with the union bolt.

    Torque:
    23 N*m{ 235 kgf*cm , 17 ft.*lbf }

  1. A117977
    Turn the retainer in the direction indicated by the arrow until the retainer stops.

  1. A117978
    Insert the fuel tube connector into the injector.

  1. A117979
    Turn the retainer in the direction indicated by the arrow until it makes a "click" sound.

    NOTICE:
    If the fuel tube connector is not inserted to the correct position in the injector, the retainer cannot be turned farther in the direction of the arrow.

  1. A114936
    Connect the exhaust fuel addition injector connector.


3. INSTALL AIR CLEANER ASSEMBLY

  1. A124928E01
    Install the cleaner case with the 3 bolts and connect the wire harness clamp.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Install the air filter element.

  1. A126824
    Using pliers, grip the claws of the clip to install the air cleaner cap.

  1. Using pliers, grip the claws of the clip and slide the clip to connect the PCV hose.

  1. A124929E01
    Insert the hinge parts of the air cleaner cap into the air cleaner case, and then hang the 3 hook clamps.

  1. Connect the mass air flow meter connector.

  1. Attach the wire harness clamp.


4. INSTALL NO. 1 ENGINE COVER

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
← INSPECTION (from Nov 2005)COMPONENTS (from Nov 2005) →