2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2007

Versions by build date: Jan 2007 – Jul 2007 from Aug 2007


1. INSTALL EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

  1. A114959
    Install a new gasket, the exhaust fuel addition injector and nozzle holder clamp with the washer and bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }

    HINT:
    Install the nozzle holder clamp while holding it.


2. INSTALL FUEL TUBE SUB-ASSEMBLY

  1. A117977
    Turn the retainer in the direction indicated by the arrow until the retainer stops.

  1. A114952
    Install a new gasket and the fuel tube with the union bolt.

    Torque:
    23 N*m{ 235 kgf*cm , 17 ft.*lbf }

  1. A117978
    Insert the fuel tube connector into the injector.

  1. A117979
    Turn the retainer in the direction indicated by the arrow until it makes a "click" sound.

    NOTICE:
    If the fuel tube connector is not inserted in the correct position to the injector, the retainer cannot be turned farther than indicated by the arrow.

  1. A114936
    Connect the exhaust fuel addition injector connector.


3. INSTALL FUEL HOSE PROTECTOR

  1. A160454
    Install the bolt, then install the fuel hose protector.

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }


4. INSTALL AIR CLEANER CASE

  1. A124928E01
    Install the cleaner case with the 3 bolts and connect the wire harness clamp.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Install the air filter element.


5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

  1. A124929E01
    Insert the hinge parts of the air cleaner cap into the air cleaner case, and then hang the 3 hook clamps.

  1. Connect the mass air flow meter connector.

  1. Engage the wire harness clamp.


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. INSPECT FOR FUEL LEAK
  1. PERFORM ACTIVE TEST

    1. Connect the intelligent tester to the DLC3.

    2. Start the engine.

    3. Turn the intelligent tester ON.

    4. Enter the following menus: Powertrain / Engine / Active Test.

    5. Perform the Active Test.

      Intelligent Tester Display
      Test Details
      Control Range
      Diagnostic Notes
      Test the Fuel Leak
      Pressurizing common rail internal fuel pressure, and checking for fuel leaks
      Stop/Start
      1. Fuel pressure inside common rail pressurized to specified value and engine speed increased to 2,000 rpm when start is selected
      2. Above conditions to be maintained while test is started


8. INSTALL NO. 1 ENGINE COVER

  1. A123518
    Attach the 4 clips to install the engine cover.

← INSTALLATION (Jan 2007 – Jul 2007)COMPONENTS (from Jan 2007) →