2005-2008 RAV4 · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2007

HINT:
In a malfunction in which the EGR system is always operating, black or white smoke may be emitted from the exhaust pipe.


CHECK SEATING OF EGR VALVE
  1. Turn the ignition switch on (IG), and then check that the engine starts and runs at idle.


CHECK HOT ENGINE CONDITION
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine, then run it at idle.

  1. Turn the intelligent tester on.

  1. Select "Powertrain / ENGINE / Active Test / Control the EGR Position" in Data List.

  1. Warm up the engine.
    The coolant temperature should be between 75°C (167°F) and 90°C (194°F).

  1. Check the EGR position.

    1. Check the MAF reading for the conditions shown in the table below when the EGR position is not 0% (EGR ON).

      Standard:
      Engine Condition
      Active Test
      MAF
      Idling
      Active test not performed
      3.6 to 7.2 g/s
      Active test performed (Operate EGR position 0%)
      5.8 to 12.4 g/s

      HINT:
      1. If the MAF reading is out of the standard range in either condition (active test performed or active test not performed), replace the EGR valve.
      2. If the MAF reading is out of the standard range in both conditions (active test performed and active test not performed), check the intake air flow meter.

      If any defects are found, replace the intake air flow meter, and then check operation of the EGR valve.

    2. Check the MAF reading for the conditions shown in the table below when the EGR position is 0% (EGR OFF).

      Standard:
      Engine Condition
      Active Test
      MAF
      Idling
      Active test not performed
      5.8 to 12.4 g/s
      Active test performed (Operate EGR position 100%)
      2.1 to 3.8 g/s

      HINT:
      1. If the MAF reading is out of the standard range in either condition (active test performed or active test not performed), replace the EGR valve.
      2. If the MAF reading is out of the standard range in both conditions (active test performed and active test not performed), check the intake air flow meter.

      If any defects are found, replace the intake air flow meter, and then check operation of the EGR valve.


VISUALLY INSPECT HOSES, CONNECTORS AND GASKETS

  1. A133239
    Check for cracks, leaks or damage.

    1. Check the engine assembly to see if the portions indicated by the arrows have any cracks, leaks or damage.

      NOTICE:
      1. Detachment or other problems with the engine oil dipstick, oil filler cap, PCV hose and other components may cause the engine to run improperly.
      2. Air suction caused by disconnections, looseness or cracks in any part of the air induction system between the throttle body and cylinder head will cause engine failure or engine malfunctions.

      If any defects are found, replace the parts as necessary.

← SYSTEM DIAGRAM (from Jan 2007)COMPONENTS (from Nov 2005) →