P0335 Crankshaft Position Sensor "A" Circuit
Diagnostic trouble codes · Vehicles built from Aug 2007
Also covers:
- P0339 Crankshaft Position Sensor "A" Circuit Intermittent
Versions by build date: Jan 2007 – Jul 2007 from Aug 2007
DESCRIPTION
The crankshaft position sensor system consists of a crankshaft position sensor plate and a pickup coil. The sensor plate has 34 teeth and is installed on the crankshaft. The pickup coil is made of an iron core and magnet. The sensor plate rotates, and a pulse signal is created as each tooth passes by the pickup coil. The pickup coil generates 34 signals for each engine revolution. Based on these signals, the ECM calculates the crankshaft position and engine RPM. Using these calculations, the common rail injection system is controlled.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0335 |
No crankshaft position sensor signal to ECM while cranking (1 trip detection logic) |
|
| P0339 |
No crankshaft position sensor signal is input to ECM for 0.05 seconds or more, and conditions (a), (b) and (c) are met: (1 trip detection logic) (a) Engine speed is at 1,000 rpm or more (b) STA signal is OFF (c) 3 seconds or more have elapsed after STA signal is switched from ON to OFF |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
| 1. INSPECT CRANKSHAFT POSITION SENSOR |
Disconnect the crankshaft position sensor connector.

Measure the resistance of the sensor.
- Standard resistance:
Tester Connection
Condition
Specified Condition
B42-1 (NE) - B42-2 (NE-)
Cold
835 to 1,400 Ω
B42-1 (NE) - B42-2 (NE-)
Hot
1,060 to 1,645 Ω
- HINT:
- In the table above, the terms "Cold" and "Hot" refer to the temperature of the coils in the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).
Reconnect the crankshaft position sensor connector.
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (CRANKSHAFT POSITION SENSOR - ECM) |
Disconnect the crankshaft position sensor connector.

Disconnect the ECM connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection
Specified Condition
B42-1 (NE) - B32-78 (NE+)
Below 1 Ω
B42-2 (NE-) - B32-77 (NE-)
Below 1 Ω
B42-1 (NE) or B32-78 (NE+) - Body ground
10 kΩ or higher
B42-2 (NE-) or B32-77 (NE-) - Body ground
10 kΩ or higher
Reconnect the crankshaft position sensor connector.
Reconnect the ECM connector.
|
|
||||
| OK | |
| 3. CHECK CRANKSHAFT POSITION SENSOR (SENSOR INSTALLATION) |
Check the sensor installation.

- OK:
- Sensor is installed correctly.
|
|
||||
| OK | |
| 4. CHECK CRANKSHAFT POSITION SENSOR PLATE NO.1 |
Check the teeth of the crankshaft timing sprocket.
- OK:
- The sensor plate's teeth do not have any cracks or deformation.
|
|
||||
| OK | ||
| ||
