2005-2008 RAV4 · Service Manual ENGINE

P0500 Vehicle Speed Sensor "A"

Diagnostic trouble codes · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007

DESCRIPTION

The skid control ECU outputs a signal that is proportional to vehicle speed. This signal is based on the rotation of the ABS wheel speed sensors. After this, the signal is converted into a more precise rectangular waveform by the waveform shaping circuit inside the combination meter. It is then transmitted to the ECM. The ECM determines the vehicle speed based on the frequency of this signal.
A115899E03
DTC No.
DTC Detection Condition
Trouble Area
P0500
Conditions (a), (b) and (c) continue for 7 seconds or more:
(2 trip detection logic)
(a) Engine coolant temperature is more than 70°C (158°F)
(b) Engine speed is between 2,000 rpm and 3,500 rpm
(c) No speed signal is input to ECM
  1. Open or short in speed sensor circuit
  2. Skid control ECU
  3. Combination meter
  4. ECM

WIRING DIAGRAM

C128774E01

INSPECTION PROCEDURE

NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).


1. CHECK OPERATION OF SPEEDOMETER
  1. Drive the vehicle.

  1. Check the speedometer reading in the combination meter.

    HINT:
    If the vehicle speed sensor signal is inaccurate, the speedometer will show abnormal readings.

    OK:
    Speedometer operates normally.



NG
CHECK SPEEDOMETER CIRCUIT (INCLUDE SPEED SENSOR)
OK


2. READ VALUE USING VEHICLE SPEED
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine and turn the tester ON.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / Vehicle Speed.

  1. Check the vehicle speed at an engine speed of 2,000 rpm or more while the vehicle is running.

    OK:
    Same value as actual vehicle speed.



OK
CHECK FOR INTERMITTENT PROBLEMS
NG


3. CHECK WIRE HARNESS (COMBINATION METER - ECM)

  1. A127855E05
    Disconnect the E22 combination meter connector.

  1. Disconnect the A12 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E22-39 (+S) - A12-14 (SPD)
    Below 1 Ω
    E22-39 (+S) or A12-14 (SPD) - Body ground
    10 kΩ or higher

  1. Reconnect the combination meter connector.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM


← P0500 Vehicle Speed Sensor "A" (Nov 2005 – Dec 2006)P0504 Brake Switch "A" / "B" Correlation (Nov 2005 – Dec 2006) →