P0168 Fuel Temperature Too High
Diagnostic trouble codes · Vehicles built from Jan 2007
DESCRIPTION
The fuel temperature sensor monitors the fuel temperature. The fuel temperature sensor has a thermistor that varies its resistance depending on the fuel temperature. When the fuel temperature is low, the resistance of the thermistor is high. When the temperature is high, the resistance is low. The variations of resistance are communicated to the ECM as changes of voltage (see Fig. 1).The fuel temperature sensor is connected to the ECM (see below). The 5 V power source voltage in the ECM is applied to the fuel temperature sensor from terminal THF via resistor R.
The resistor R and fuel temperature sensor are connected in series. When the resistance value of the fuel temperature sensor changes due to a change of fuel temperature, the voltage at terminal THF also changes. Based on this signal, the ECM corrects the pressure control compensation of the supply pump and determines errors.


| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0168 |
Conditions (a) and (b) continue for more than 1 second with engine speed at 1400 rpm or more: (1 trip detection logic) (a) Fuel temperature is more than 96°C (205°F) (b) Vehicle speed is more than 10 km/h (6.2 mph) |
Fuel temperature sensor |
INSPECTION PROCEDURE
- HINT:
- If DTCs P0180, P0182, or P0183 is set at the same time as P0168, the fuel temperature sensor may have an open or a short circuit. Troubleshoot those DTCs first.
| 1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0168) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
- Result:
Display (DTC Output)
Proceed to
P0168
A
P0168 and other DTCs
B
- HINT:
- If DTCs other than P0168 are output, perform troubleshooting for those codes first.
|
|
||||
| A | ||
| ||
