P0045 Turbocharger / Supercharger Boost Control Solenoid Circuit / Open
Diagnostic trouble codes · Vehicles built from Jan 2007
DESCRIPTION
| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0045 |
Open or short in vacuum regulating valve circuit for 0.5 seconds or more (1 trip detection logic) |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT VACUUM REGULATING VALVE (RESISTANCE) |
Disconnect the vacuum regulating valve connector.

Measure the resistance of the vacuum regulating valve.
- Standard resistance:
Tester Connection
Condition
Specified Condition
B44-1 - B44-2
20°C (68°F)
11.1 to 12.5 Ω
Reconnect the vacuum regulating valve connector.
|
|
||||
| OK | |
| 2. INSPECT VACUUM REGULATING VALVE (TERMINAL 1 VOLTAGE) |
Disconnect the vacuum regulating valve connector.

Turn the ignition switch on (IG).
Measure the voltage of the vacuum regulating valve connector.
- Standard voltage:
Tester Connection
Specified Condition
B44-1 - Body ground
9 to 14 V
Reconnect the vacuum regulating valve connector.
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (VACUUM REGULATING VALVE - ECM) |
Disconnect the vacuum regulating valve connector.

Disconnect the ECM connector.
Measure the resistance of the wire harness connector.
- Standard resistance:
Tester Connection
Specified Condition
B44-2 - B32-84 (VN)
Below 1 Ω
B44-2 or B32-84 (VN) - Body ground
10 kΩ or higher
Reconnect the vacuum regulating valve connector.
Reconnect the ECM connector.
|
|
||||
| OK | ||
| ||
