2005-2008 RAV4 · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2005


CHECK MANIFOLD ABSOLUTE PRESSURE SENSOR

  1. A124891E01
    Inspect power source voltage.

    1. Disconnect the manifold absolute pressure sensor connector.

    2. Turn the ignition switch on (IG).

    3. Using a voltmeter, measure the voltage between connector terminals 3 (VC) and 1 (E2) of the wiring harness side.

      Standard voltage:
      4.5 to 5.5 V

    4. Turn the ignition switch off.

    5. Reconnect the manifold absolute pressure sensor connector.

  1. Check the vacuum and pressure.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG) and turn the tester ON.

    3. Enter the following menus: Powertrain / Engine and ECT / Data List / MAP and Atmosphere Pressure.

    4. Read the value.

      OK:
      Condition
      MAP Value
      No pressure applied
      Same as atmospheric pressure
      Vacuum applied
      Becomes vacuum
      Pressure applied
      Becomes pressure

      If the result is not as specified, replace the manifold absolute pressure sensor.

← INSTALLATION (from Nov 2005)ON-VEHICLE INSPECTION (from Nov 2005) →