ON-VEHICLE INSPECTION
Inspection · Vehicles built from Nov 2005
| CHECK MANIFOLD ABSOLUTE PRESSURE SENSOR |
Inspect power source voltage.

Disconnect the manifold absolute pressure sensor connector.
Turn the ignition switch on (IG).
Using a voltmeter, measure the voltage between connector terminals 3 (VC) and 1 (E2) of the wiring harness side.
- Standard voltage:
- 4.5 to 5.5 V
Turn the ignition switch off.
Reconnect the manifold absolute pressure sensor connector.
Check the vacuum and pressure.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / MAP and Atmosphere Pressure.
Read the value.
- OK:
Condition
MAP Value
No pressure applied
Same as atmospheric pressure
Vacuum applied
Becomes vacuum
Pressure applied
Becomes pressure
