2005-2008 RAV4 · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. REMOVE FUEL EMISSION HOSE

  1. A127856
    Disconnect the EVAP line tube.


2. REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY

  1. A125358
    Remove the 2 joint clips, fuel tank main tube and return tube.

    CAUTION:
    1. Before removing the tube joint clips, check for foreign matter around each clip. Clean if necessary.
    1. Do not use any tools in this procedure.
    1. Do not forcefully bend or twist the tube.
    1. Put the tube in a plastic bag to prevent damage and contamination.
    1. If the fuel suction plate and tube are stuck together, pinch the tube and turn it carefully to disconnect it.
    1. Be careful not the damage any clips. If a clip is damaged, replace it.


3. REMOVE FUEL TANK VENT TUBE SET PLATE

  1. A125359
    Remove the 8 bolts and set plate.


4. REMOVE FUEL SUCTION VENT TUBE ASSEMBLY

  1. A125360
    Disconnect the fuel hose and remove the suction vent tube assembly.

    NOTICE:
    Do not damage the suction vent tube assembly.

  1. Remove the gasket from the suction vent tube assembly.


5. REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY

  1. A125367
    Remove the fuel tank main tube from the fuel tube clamp.


6. REMOVE FUEL TANK RETURN TUBE
  1. Remove the return tube from the fuel tube clamp.


7. REMOVE NO. 1 FUEL TUBE CLAMP
  1. Remove the 4 fuel tube clamps from the fuel tank.


8. REMOVE NO. 1 FUEL TANK CUSHION

  1. A124667
    Remove the 7 fuel tank cushions from the fuel tank.


9. REMOVE FUEL SENDER GAUGE ASSEMBLY

  1. A124670
    Remove the 5 screws and sender gauge.

← REMOVAL (from Nov 2005)REASSEMBLY (from Nov 2005) →