2005-2008 RAV4 · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built Nov 2005 – Jul 2008

Versions by build date: Nov 2005 – Jul 2008 from Aug 2008


1. INSTALL FUEL SENDER GAUGE ASSEMBLY

  1. A124671
    Install the sender gauge with the 5 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }


2. INSTALL NO. 1 FUEL TANK CUSHION

  1. A124667
    Install 7 new fuel tank cushions onto the fuel tank as shown in the illustration.


3. INSTALL NO. 1 FUEL TUBE CLAMP

  1. A124672
    Install the 4 tube clamps to the fuel tank.


4. INSTALL FUEL EVAPORATION TUBE SUB-ASSEMBLY
  1. Install the tube to the fuel tube clamps.


5. INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
  1. Install the tube to the fuel tube clamps.


6. INSTALL FUEL SUCTION WITH PUMP ASSEMBLY

  1. A126699E02
    Install a new gasket onto the fuel pump.

  1. A131634
    Connect the fuel hose and install the fuel pump into the fuel tank.

    NOTICE:
    Do not damage the fuel pump filter.


7. INSTALL FUEL TANK VENT TUBE SET PLATE

  1. A124675
    Install the set plate with the 8 bolts.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }


8. INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY

  1. A124668
    Install the fuel tube with the joint clip.

    CAUTION:
    A124131E01
    1. Check that there are no scratches or foreign objects on the connecting parts.
    1. Check that the fuel tube joint is inserted securely.
    1. Check that the fuel tube joint clip is on the collars of the fuel tube joint.
    1. After installing the tube joint clip, check that the fuel tube joint has not been pulled off.
    1. Be careful not to damage the clip. If the clip is damaged, replace it.


9. INSTALL FUEL EMISSION HOSE

  1. A124674
    Install the purge line hose, air inlet line hose and EVAP line tube to the fuel pump.

← DISASSEMBLY (from Aug 2008)REASSEMBLY (from Aug 2008) →