2005-2008 RAV4 · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005


1. INSTALL FUEL SENDER GAUGE ASSEMBLY

  1. A124671
    Install the sender gauge with the 5 screws.


2. INSTALL NO. 1 FUEL TANK CUSHION

  1. A124667
    Install 7 new fuel tank cushions onto the fuel tank as shown in the illustration.


3. INSTALL NO. 1 FUEL TUBE CLAMP

  1. A125367
    Install the 4 fuel tube clamps to the fuel tank.


4. INSTALL FUEL TANK RETURN TUBE
  1. Install the return tube to the fuel tube clamps


5. INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
  1. Install the main tube to the fuel tube clamps.


6. INSTALL FUEL SUCTION VENT TUBE ASSEMBLY

  1. A125360
    Install a new gasket onto the suction vent tube assembly.

  1. Connect the fuel hose and install the suction vent tube assembly into the fuel tank.

    NOTICE:
    Do not damage the suction vent tube assembly filter.


7. INSTALL FUEL TANK VENT TUBE SET PLATE

  1. A125359
    Install the set plate with the 8 bolts.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }


8. DISCONNECT TANK MAIN TUBE SUB-ASSEMBLY

  1. A125361
    Install the fuel tube with the joint clips.

    CAUTION:
    1. Check that there are no scratches or foreign objects on the connecting parts.
    1. Check that the fuel tube joint is inserted securely.
    1. Check that the fuel tube joint clip is on the collars of the fuel tube joint.
    1. After installing the tube joint clips, check that the fuel tube joint has not been pulled off.

    1. A124131E01
      Be careful not to damage any clips. If a clip is damaged, replace it.


9. INSTALL FUEL EMISSION HOSE

  1. A127856
    Connect the EVAP line tube.

← DISASSEMBLY (from Nov 2005)INSTALLATION (Nov 2005 – Dec 2006) →