2005-2008 RAV4 · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2005

HINT:
The type of ignition switch on this model differs according to the specifications, of the vehicle. For the expressions used in this section, refer to "EXPRESSIONS OF IGNITION SWITCH" precaution (Click here).


CHECK ACCELERATOR PEDAL ROD

  1. B127990E01
    Check the voltage.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Turn the intelligent tester ON.

    4. Select the menu items: Powertrain / Engine and ECT / Data List / All Data / Accelerator Position No. 1, Accelerator Position No. 2.

    5. Operate the accelerator pedal, and then check that the ACCEL POS #1 and ACCEL POS #2 values are within the specifications.

      Standard voltage (Accelerator Position No. 1):
      Accelerator Pedal Condition
      Specified Condition
      Released
      0.5 to 1.1 V
      Depressed
      2.5 to 4.5 V

      Standard voltage (Accelerator Position No. 2):
      Accelerator Pedal Condition
      Specified Condition
      Released
      1.2 to 2.0 V
      Depressed
      3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal rod, wire harness or ECM.

← COMPONENTS (from Nov 2005)REMOVAL (from Nov 2005) →