ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2007
| CHECK ACCELERATOR PEDAL ROD |
Check the voltage.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Accelerator Position No. 1, Accelerator Position No. 2.
Operate the accelerator pedal, and then check that the values of Accelerator Position No. 1 and Accelerator Position No. 2 are within the specifications.
- Standard voltage:
- Accelerator Position No. 1
Accelerator Pedal Condition
Specified Condition
Released
0.5 to 1.1 V
Depressed
2.5 to 4.5 V
- Accelerator Position No. 2:
Accelerator Pedal Condition
Specified Condition
Released
1.2 to 2.0 V
Depressed
3.4 to 5.0 V
