B1630/23 Driver Side Rear Airbag Sensor Circuit Malfunction
Diagnostic trouble codes · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
DESCRIPTION
The driver side rear airbag sensor consists of parts including the diagnostic circuit and the lateral deceleration sensor.When the center airbag sensor receives signals from the lateral deceleration sensor, it determines whether or not the SRS should be activated.
DTC B1630/23 is recorded when a malfunction is detected in the driver side rear airbag sensor circuit.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1630/23 |
When one of following conditions is met:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK DRIVER SIDE REAR AIRBAG SENSOR |
![]() ![]() |
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Interchange the driver side rear airbag sensor with the front passenger side rear airbag sensor and connect the connectors to them.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the ignition switch on (IG), and wait for at least 60 seconds.
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the ignition switch on (IG), and wait for at least 60 seconds.
Check the DTCs (Click here).
Result Result
Proceed to
DTC B1630/23 and B1635/24 are not output.
A
DTC B1630/23 is output.
B
DTC B1635/24 is output.
C
- HINT:
- DTCs other than DTC B1630/23 and B1635/24 may be output at this time, but they are not related to this check.
|
|
||||
|
|
||||
| A | ||
| ||

