2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE AIR CLEANER CAP

  1. A124927E01
    Disconnect the mass air flow meter connector.

  1. Disconnect the wire harness clamp.

  1. Unhook the 3 hook clamps, and then remove the air cleaner cap.

  1. Remove the air cleaner filter element from the air cleaner case.


3. REMOVE AIR CLEANER CASE

  1. A124928E01
    Disconnect the wire harness clamp and remove the 3 bolts and air cleaner case.


4. REMOVE NO. 1 ENGINE COVER

  1. A123518
    Detach the 4 clips and remove the engine cover.


5. DRAIN ENGINE COOLANT
  1. Loosen the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator reservoir cap.

    CAUTION:
    Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the cylinder block drain cock plug.

    A126839E01


6. REMOVE ENGINE COOLANT TEMPERATURE SENSOR

  1. A124884
    Disconnect the sensor connector.

  1. Remove the sensor and gasket.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →