2005-2008 RAV4 · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2005


CHECK FUEL PRESSURE
  1. READ DATA LIST

    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the intelligent tester to the DLC3.

    4. Start the engine.

    5. Turn the intelligent tester ON.

    6. Enter the following menus: Powertrain / Engine / Data List.

    7. Read the Data list.

      Intelligent Tester Display
      Measurement Item/Range (Display)
      Normal Conditions
      Fuel Press
      Fuel pressure / Min.: 0 MPa, Max.: 655.350 MPa
      35 to 40 MPa: Idling
      Target Common Rail Pressure
      Target common rail pressure/ Min.: 0 kPa, Max.: 655350 kPa
      20 to 170 MPa


CHECK FOR FUEL LEAKS
  1. PERFORM ACTIVE TEST

    1. Connect the intelligent tester to the DLC3.

    2. Start the engine.

    3. Turn the intelligent tester ON.

    4. Enter the following menus: Powertrain / Engine / Active Test.

    5. Perform the Active Test.

      Intelligent Tester Display
      Test Details
      Control Range
      Diagnostic Notes
      Test the Fuel Leak
      Pressurizing common rail internal fuel pressure, and checking for fuel leaks
      Stop/Start
      1. Fuel pressure inside common rail pressurized to specified value and engine speed increased to 2,000 rpm when start is selected
      2. Above conditions to be maintained while test is started


BLEED AIR FROM FUEL SYSTEM

  1. A131613
    Using the hand pump indicated by the arrows in the illustration, bleed the fuel system. Continue pumping until pumping becomes difficult.


CHECK FUEL FILTER WARNING LIGHT AND DRAIN WATER

  1. A130644
    Check the fuel filter warning light.

    NOTICE:
    When the fuel filter warning light illuminates and the buzzer sounds, the water in the fuel filter must be drained immediately.

  1. A134872E01
    Remove the drain plug and place a small tray to catch the water.

  1. Operate the hand pump until only fuel begins to run out.

  1. After draining, retighten the drain plug.

    NOTICE:
    Do not use any tools.

← SYSTEM DIAGRAM (from Nov 2005)COMPONENTS (from Nov 2005) →