REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
| 1. REMOVE BLOWER UNIT ASSEMBLY |
Remove the blower (Click here).
| 2. REMOVE AIR INLET CONTROL SERVO MOTOR |
Inspect the servo motor operation.

Connect the positive (+) lead from the battery to terminal 4 and negative (-) lead to terminal 5, and then check that the arm turns to the "FRESH" side smoothly.

Connect the positive (+) lead from the battery to terminal 5 and negative (-) lead to terminal 4, and then check that the arm turns to the "RECIRCULATION" side smoothly.
If the operation is not as specified, replace the air inlet control servo motor.
