2005-2008 RAV4 · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

B129996
  1. Remove the 2 screws.

  1. Detach the 2 claws and remove the instrument panel under cover.


3. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag)

B127987
  1. Remove the 4 bolts and driver side knee airbag.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.


4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

B132919
  1. Remove the 2 screws.

  1. Using a screwdriver, detach the 8 claws and remove the lower instrument panel finish panel.

    HINT:
    Tape the screwdriver tip before use.


5. DRAIN BRAKE FLUID

NOTICE:
Wash brake fluid off immediately if it adheres to any painted surface.


6. DISCONNECT CLUTCH RESERVOIR TUBE

C127490E01
  1. Loosen the clip and disconnect the tube from the clutch master cylinder.

    HINT:
    Use a container to catch the fluid.


7. DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

C127491E01
  1. Using SST, disconnect the flexible hose tube.

    SST
    09023-00101  

    HINT:
    Use a container to catch the fluid.


8. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY

C132128E01
  1. Remove the 2 nuts and clutch master cylinder.

← REMOVAL (Nov 2005 – Dec 2006)INSTALLATION (Nov 2005 – Dec 2006) →