2005-2008 RAV4 · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007

CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE STEERING PAD ASSEMBLY

B130245E01
  1. Straighten the front wheels.

  1. Using a T30 "torx" driver, loosen the 2 screws until the groove along each screw circumference catches on the screw case.

  1. B127893E01
    Pull out the steering pad from the steering wheel and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Using a screwdriver, disconnect the 2 airbag connectors.

    CAUTION:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Disconnect the horn connector and remove the steering pad.


3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

4. REMOVE STEERING WHEEL ASSEMBLY

  1. C132123E01
    Remove the nut and place matchmarks on the steering wheel and steering column.

  1. C132124E02
    Using SST, remove the steering wheel.
    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply a small amount of grease to the threads and tip of SST (center bolt) before use.


5. REMOVE STEERING COLUMN COVER (LOWER)

  1. C128491
    Detatch the 4 claws, release the tilt lever and remove the lower steering column cover.

  1. C128492
    Detach the claw and remove the upper steering column cover.


6. REMOVE SPIRAL CABLE SUB-ASSEMBLY

  1. B127900E01
    Rise the steering column cover (upper).

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. B127901E01
    Detach the 4 clips and remove the column cover (upper).

  1. B127902E01
    Detach the 3 claws and remove the spiral cable.

← COMPONENTS (from Nov 2005)REMOVAL (from Jan 2007) →