REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
- CAUTION:
- Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY |
| 3. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY |
Detach the wire harness clamp from bracket.
Disconnect the connector from the airbag.

- NOTICE:
- When handling the airbag connector, do not damage the airbag wire harness.
Remove the 2 bolts from the reinforcement.
Remove the instrument panel upper (Click here).
Release the front side airbag door from the front side hook by slightly bending it and lift out the front passenger airbag rearward.

Release the rear side airbag door from the other hook and remove the front passenger airbag.
