2005-2008 RAV4 · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).


1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY

B127906E01
  1. Install the airbag sensor with the 3 bolts.

    Torque:
    17.5 N*m{ 179 kgf*cm , 13 ft.*lbf }

    NOTICE:
    1. If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
    2. When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Connect the airbag sensor connectors.


2. INSTALL REAR CONSOLE BOX ASSEMBLY

B129878
  1. Connect the connector.

  1. Install the rear console box with the 2 bolts and 2 screws.

  1. Install the console box carpet.


3. INSTALL NO. 1 INSTRUMENT PANEL BRACKET COVER INNER LH

B129877
  1. Attach the 2 claws to install the instrument panel bracket cover.


4. INSTALL NO. 1 INSTRUMENT PANEL BRACKET COVER INNER RH

B129876
  1. Attach the 2 claws to install the instrument panel bracket cover.


5. INSTALL CONSOLE REAR END PANEL

B129879
  1. Attach the 6 claws to install the console rear end panel.


6. INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY

B129880
  1. Connect the connector.

  1. Attach the 4 clips to install the upper rear console panel.


7. INSTALL CONSOLE CUP HOLDER BOX

B129881
  1. Attach the 2 clips to install the cup holder box.

  1. Install the 2 screws.


8. INSTALL SWITCH BASE

B129882
  1. Connect the connectors.

  1. Attach the 2 clips and 2 claws to install the switch base.


9. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

B129883
  1. Automatic transaxle:
    Connect the connector.

  1. Attach the 2 clips and 4 claws to install the upper console panel.

  1. Install the shift lever knob.


10. INSTALL NO. 2 CONSOLE UPPER PANEL GARNISH

B129884
  1. Attach the 4 clips to install the upper panel garnish.


11. INSTALL NO. 1 CONSOLE UPPER PANEL GARNISH

B129885
  1. Attach the 4 clips to install the upper panel garnish.


12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

13. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).

← INSTALLATION (Nov 2005 – Dec 2006)INSTALLATION (from Aug 2007) →