REMOVAL
Removal / installation · Vehicles built from Jan 2007
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
- CAUTION:
- Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE NO. 1 CONSOLE UPPER PANEL GARNISH
|
 |
Using a screwdriver, detach the 4 clips and upper panel garnish.
- HINT:
- Tape the screwdriver tip before use.
| 3.
REMOVE NO. 2 CONSOLE UPPER PANEL GARNISH
|
 |
Using a screwdriver, detach the 4 clips and upper panel garnish.
- HINT:
- Tape the screwdriver tip before use.
| 4.
REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
|
 |
Remove the shift lever knob.
for Manual Transaxle:
Using a screwdriver, detach the 2 clips, 4 claws and remove the upper console panel.
- HINT:
- Tape the screwdriver tip before use.
for Automatic Transaxle:
Using a screwdriver, detach the 2 clips, 4 claws and remove the upper console panel then disconnect the connector.
- HINT:
- Tape the screwdriver tip before use.
| 5.
REMOVE SWITCH BASE
|
 |
Detach the 2 clips and 2 claws.
Disconnect the connectors and remove the switch base.
| 6.
REMOVE CONSOLE CUP HOLDER BOX
|
 |
Remove the 2 screws.
Detach the 2 clips and remove the cup holder box.
| 7.
REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY
|
 |
Using a screwdriver, detach the 4 clips.
- HINT:
- Tape the screwdriver tip before use.
Disconnect the connector and remove the upper rear console panel.
| 8.
REMOVE CONSOLE REAR END PANEL
|
 |
Using a screwdriver, detach the 6 claws and remove the console rear end panel.
- HINT:
- Tape the screwdriver tip before use.
| 9.
REMOVE NO. 1 INSTRUMENT PANEL BRACKET COVER INNER LH
|
 |
Detach the 2 claws and remove the instrument panel bracket cover.
| 10.
REMOVE NO. 1 INSTRUMENT PANEL BRACKET COVER INNER RH
|
 |
Detach the 2 claws and remove the instrument panel bracket cover.
| 11.
REMOVE REAR CONSOLE BOX ASSEMBLY
|
 |
Remove the console box carpet.
Remove the 2 bolts and 2 screws.
Disconnect the connector and remove the rear console box.
| 12.
REMOVE CENTER AIRBAG SENSOR ASSEMBLY |
 |
Disconnect the airbag sensor connectors.
Remove the 3 bolts and airbag sensor.