INSTALLATION
Removal / installation · Vehicles built from Jan 2007
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
- CAUTION:
- Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here ).
| 1. INSTALL FRONT AIRBAG SENSOR LH |
![]() ![]() |
Install the sensor with the bolt.
- Torque:
- 9.0 N*m{ 92 kgf*cm , 80 in.*lbf }
- NOTICE:
- If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
- When installing the airbag sensor, make sure that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
Check that there is no free play in the installation parts of the sensor.
Connect the sensor connector.
| 2. INSTALL FRONT AIRBAG SENSOR RH |
![]() ![]() |
Install the sensor with the bolt.
- Torque:
- 9.0 N*m{ 92 kgf*cm , 80 in.*lbf }
- NOTICE:
- If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
- When installing the airbag sensor, make sure that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
Check that there is no free play in the installation parts of the sensor.
Connect the sensor connector.
| 3. INSTALL RADIATOR SUPPORT OPENING COVER |
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).



